Cisco CCNP 642-813 Exam Questions 05

Ensurepass

QUESTION
A network administrator wants to configure 802.1x port-based authentication, however, the client workstation is not 802.1x compliant. What is the only supported authentication server that can be used?

A. TACACS with LEAP extensions
B. TACACS+
C. RADIUS with EAP extensions
D. LDAP

Correct Answer: C

QUESTION 27
The following command was issued on a router that is being configured as the active HSRP router.

standby ip 10.2.1.1

Which statement about this command is true?

A. This command will not work because the HSRP group information is missing.
B. The HSRP MAC address will be 0000.0c07.ac00.
C. The HSRP MAC address will be 0000.0c07.ac01.
D. The HSRP MAC address will be 0000.070c.ac11.
E. This command will not work because the active parameter is missing.

Correct Answer: B

QUESTION 28
Refer to the exhibit.

The link between switch SW1 and switch SW2 is configured as a trunk, but the trunk failed to establish connectivity between the switches. Based on the configurations and the error messages received on the console of SW1, what is the cause of the problem?

A. The two ends of the trunk have different duplex settings.
B. The two ends of the trunk have different EtherChannel configurations.
C. The two ends of the trunk have different native VLAN configurations.
D. The two ends of the trunk allow different VLANs on the trunk.

Correct Answer: C

QUESTION 29
A campus infrastructure supports wireless clients via Cisco Aironet AG Series 1230, 1240, and 1250 access points. With DNS and DHCP configured, the 1230 and 1240 access points appear to boot and operate normally. However, the 1250 access points do not seem to operate correctly.
What is the most likely cause of this problem?

A. DHCP with option 150
B. DHCP with option 43
C. PoE
D. DNS
E. switch port does not support gigabit speeds
Correct Answer: C

QUESTION 30
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly, but wireless clients are not obtaining correct access. You verify that this is the local switch configuration connected to the access point:

What is the most likely cause of the problem?

A. QoS trust should not be configured on a port attached to a standalone AP.
B. QoS trust for switchport mode access should be defined as “cos”.
C. switchport mode should be defined as “trunk” with respective QoS.
D. switchport access vlan should be defined as “1”.

Correct Answer: C

Ensurepass offers the Latest 2013 642-813 Exam PDF to pass the exams.