Which two DTP modes permit trunking between directly connected switches? (Choose two.)
A. dynamic desirable (VTP domain A) to dynamic desirable (VTP domain A)
B. dynamic desirable (VTP domain A) to dynamic desirable (VTP domain B)
C. dynamic auto (VTP domain A) to dynamic auto (VTP domain A)
D. dynamic auto (VTP domain A) to dynamic auto (VTP domain B)
E. dynamic auto (VTP domain A) to nonegotiate (VTP domain A)
F. nonegotiate (VTP domain A) to nonegotiate (VTP domain B)
Correct Answer: A,F
Which two RSTP port roles include the port as part of the active topology? (Choose two.)
Correct Answer: AB
Which two statements correctly describe characteristics of the PortFast feature? (Choose two.)
A. STP is disabled on the port.
B. PortFast can also be configured on trunk ports.
C. PortFast is needed to enable port-based BPDU guard.
D. PortFast is used for STP and RSTP host ports.
E. PortFast is used for STP-only host ports.
Correct Answer: B,D
Which statement correctly describes the Cisco implementation of RSTP?
A. PortFast, UplinkFast, and BackboneFast specific configurations are ignored in Rapid PVST mode.
B. RSTP is enabled globally and uses existing STP configuration.
C. Root and alternative ports transition immediately to the forwarding state.
D. Convergence is improved by using subsecond timers for the blocking, listening, learning, and forwarding port states.
Correct Answer: B
What is the effect of applying the switchport trunk encapsulation dot1q command to a port on a Cisco Catalyst switch?
A. By default, native VLAN packets going out this port are tagged.
B. Without an encapsulation command, 802.1Q is the default encapsulation if DTP fails to negotiate a trunking protocol.
C. The interface supports the reception of tagged and untagged traffic.
D. If the device connected to this port is not 802.1Q-enabled, it is unable to handle 802.1Q packets.
Correct Answer: C