Cisco CCNP 642-813 Exam Questions 20

Ensurepass

QUESTION
Refer to the exhibit.

Which statement about the private VLAN configuration is true?

A. Only VLAN 503 will be the community PVLAN, because multiple community PVLANs are not allowed.
B. Users of VLANs 501 and 503 will be able to communicate.
C. VLAN 502 is a secondary VLAN.
D. VLAN 502 will be a standalone VLAN, because it is not associated with any other VLANs.

Correct Answer: C

QUESTION 102
When configuring a routed port on a Cisco multilayer switch, which configuration task is needed to enable that port to function as a routed port?
A. Enable the switch to participate in routing updates from external devices with the router command in global configuration mode.
B. Enter the no switchport command to disable Layer 2 functionality at the interface level.
C. Each port participating in routing of Layer 3 packets must have an IP routing protocol assigned on a per-interface level.
D. Routing is enabled by default on a multilayer switch, so the port can become a Layer 3 routing interface by assigning the appropriate IP address and subnet information.

Correct Answer: B

QUESTION 103
You have configured a Cisco Catalyst switch to perform Layer 3 routing via an SVI and you have assigned that interface to VLAN 20. To check the status of the SVI, you issue the show interfaces vlan 20 command at the CLI prompt. You see from the output display that the interface is in an up/up state. What must be true in an SVI configuration to bring the VLAN and line protocol up?

A. The port must be physically connected to another Layer 3 device.
B. At least one port in VLAN 20 must be active.
C. The Layer 3 routing protocol must be operational and receiving routing updates from neighboring peer devices.
D. Because this is a virtual interface, the operational status is always in an “up/up” state.

Correct Answer: B

QUESTION 104
Refer to the exhibit, which is from a Cisco Catalyst 3560 Series Switch.

Which statement about the Layer 3 routing functionality of the interface is true?

A. The interface is configured correctly for Layer 3 routing capabilities.
B. The interface needs an additional configuration entry to enable IP routing protocols.
C. Since the interface is connected to a host device, the spanning-tree portfast command must be added to the interface.
D. An SVI interface is needed to enable IP routing for network 192.20.135.0.

Correct Answer: A

QUESTION 105
What is the result of entering the command port-channel load-balance src-dst-ip on an Ether Channel link?

A. Packets are distributed across the ports in the channel based on the source and destination MAC addresses.
B. Packets are distributed across the ports in the channel based on the source and destination IP addresses.
C. Packets are balanced across the ports in the channel based first on the source MAC address, then on the destination MAC address, then on the IP address.
D. Packets are distributed across the access ports in the channel based first on the source IP address and then on the destination IP addresses.

Correct Answer: B

Ensurepass offers the Latest 2013 642-813 Exam PDF to pass the exams.