[Free] 2017(Aug) EnsurePass Examcollection Cisco 300-115 Dumps with VCE and PDF 181-190

Ensurepass.com : Ensure you pass the IT Exams
2017 Aug Cisco Official New Released 300-115
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/300-115.html

Implementing Cisco IP Switched Networks

Question No: 181

Which option describes a limitation of LLDP?

  1. LLDP cannot provide information about VTP.

  2. LLDP does not support TLVs.

  3. LLDP can discover only Windows servers.

  4. LLDP can discover up to two devices per port.

Answer: A

Question No: 182

Refer to the exhibit.

image

How can the traffic that is mirrored out theGigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1 port?

  1. Change the configuration for GigabitEthernet0/48 so that it is a member of VLAN 10.

  2. Add an access list to GigabitEthernet0/48 to filter out traffic that is not in VLAN 10.

  3. Apply the monitor session filter globally to allow only traffic from VLAN 10.

  4. Change the monitor session source to VLAN 10 instead of the physical interface.

Answer: C

Question No: 183

What is the command forconfiguring root guard?

  1. (config) spanning-tree guard root

  2. (config-if) spanning-tree guard root

Answer: B

Question No: 184

A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?

  1. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.

  2. The port is removed from the EtherChannel group.

  3. The port is put in the errdisabled state and can only be reenabled manually.

  4. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.

Answer: D

Question No: 185

An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to reach the web server. What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web server?

  1. Enable Cisco Express Forwarding to allow for more effective traffic sharing over the EtherChannel bundle.

  2. Adjust the EtherChannel load-balancing method based on destination IP addresses.

  3. Disable spanning tree on all interfaces that are participating in the EtherChannel bundle.

  4. Use link-state tracking to allow for improved load balancing of traffic upon link failure to the server.

  5. Adjust the EtherChannel load-balancing method based on source IP addresses.

Answer: E

Question No: 186

In regards to Cisco Virtual Switching System, which technology is needed between two switches for them to act as one network element and share control information and data traffic ?

  1. virtual port channel

  2. EtherChannel

  3. virtual switch link

  4. trunk

Answer: C

Question No: 187

Which statement about the UDLD protocol is true?

  1. UDLD is a Cisco-proprietary Layer 2 protocol that enables devices to monitor the physical status of links and detect unidirectional failures.

  2. UDLD is a Cisco-proprietary Layer 2 protocol that enables devices to advertise their identity, capabilities, and neighbors on a local area network.

  3. UDLD is a standardized Layer 2 protocol that enables devices to monitor the physical status of links and detect unidirectional failures.

  4. UDLD is a standardized Layer 2 protocol that enables devices to advertise their identity, capabilities, and neighbors on a local area network.

Answer: A

Question No: 188

Refer to the exhibit.

image

All ports are members of VLAN 10. Considering the default cost of upstream bridges to the root bridge is equal, which option will be the new root port for VLAN 10?

  1. interface f0/13

  2. interface f0/14

  3. interface f0/15

  4. interface f0/21

Answer: D

Question No: 189

You administer a network that uses two routers, R1 and R2, configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows:

R1#configure terminal R1(config)#interface fa0/0

R1(config-if)#ip address 10.10.0.5 255.255.255.0

R1(config-if)#standby 1 priority 150

R1(config-if)#standbypreempt delay minimum 50 R1(config-if)#standby 1 track interface fa0/2 15

R1(config-if)#standby 1 ip 10.10.0.20

Which of the following describes the effect the quot;standby preempt delay minimum 50quot; command will have on router R1? (Select the best answer.)

  1. The HSRP priority for router R1 will increase to 200.

  2. Router R1 will become the standby router if the priority drops below 50.

  3. The HSRP priority for router R1 will decrease to 50 points when Fa0/2 goes down.

  4. Router R1 will wait 50 seconds beforeattempting to preempt the active router.

Answer: D

Question No: 190

Which command creates a login authentication method named quot;loginquot; that will primarily use RADIUS and fail over to the local user database?

  1. (config)# aaa authentication login default radius local

  2. (config)# aaa authentication login login radius local

  3. (config)# aaa authentication login default local radius

  4. (config)# aaa authentication login radius local

Answer: B

100% Ensurepass Free Download!
Download Free Demo:300-115 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass 300-115 Dumps
Get 10% off your purchase! Copy it:TJDN-947R-9CCD [2017.07.01-2017.07.31]

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

Leave a Reply