CCIE Routing and Switching (v5.1)
Question No: 221 DRAG DROP – (Topic 2)
Drag and drop each step in the performance-monitoring configuration process on the left into the correct order on the right.
Question No: 222 – (Topic 2)
What are the two BFD modes? quot;(Choose two)
Question No: 223 – (Topic 2)
Refer to exhibit. Which statement about the 192.168.100.0/24 destination network is true?
The Reported distance for the Successor is 128256
The metric installed into the route tabel is 4352
The metric installed into the route table is 126256
The Reported Distance for the Feasible Successor is 409600
Explanation: QUESTN 55
which two statements are true about an EVPL? (Choose two ) A.it does not allow for service multiplexing
B.It has a high degree of transparency
C.The EVPL service is also referred to as E-line
D.It is a point-to-point Ethernet connection between a pair 01UNls
Question No: 224 – (Topic 2)
Which two statement about VPLS are true? (Choose two)
Split horizon is used on PE devices to prevent loops.
IP is used to switch Ethernet frames between sites.
Spanning tree is extended from CE to CE
VPLS extends a layer 2 broadcast domain.
PE routers dynamic associate to peers.
Question No: 225 – (Topic 2)
Which statement describes Cisco PfR link group?
Link groups enable Cisco PfR Fast Reroute when NwtFlow is enabled on the external interfaces of the border routers.
Link groups define a strict or loose hop-by-hop path preference.
Link groups are required only when Cisco PfR is configured to load-balance all traffic.
Link groups are enabled automatically when Cisco PfR is in Fast Reroute mode.
Link groups set a preference for primary and fallback (backup) external exit interfaces.
Question No: 226 – (Topic 2)
Refer to the exhibit.
When you apply these configurations to R1 and R2. which two effects occur? (Choose two)
The 172.16.1.1 network is reachable via OSPF on R1
RI authenticates using the username Cisco
C. R1 and R2 successfully authenticates using CHAP
Authentication between R1 and R2 fails.
R1 and R2 authentications using PAP
Question No: 227 – (Topic 2)
Refer to the exhibit.
Which additional configuration statement is required on R3 in order to allow multicast traffic sourced from 192.168.13.3 to flow along the shared-tree?
A. ip route 192.168.14.0 255.255.255.0 Tunnel 0
B. ip route 10.4.4.4 255.255255.255 Tunnel 0
C. ip mroute 10.4.4.4 255.255.255.255 Tunnel 0
D. ip mroute 192.168.14.0 255.255.255.0 Tunnel 0
Question No: 228 – (Topic 2)
What are the three variants of NTPv4? (Choose three.)
Question No: 229 – (Topic 2)
According to the networking best practices .which network device should be used for optimization and rate limiting?
the provider core device
the provider edge device
the customer core device
the coustomer edge device
Question No: 230 – (Topic 2)
Which IPv4 feature prevents multicast joins on a per-port basis?
100% Ensurepass Free Download!
Download Free Demo:400-101 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass 400-101 Dumps
Get 10% off your purchase! Copy it:TJDN-947R-9CCD [2017.07.01-2017.07.31]
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|