Cisco CCNP 642-813 Exam Questions 28

Ensurepass QUESTION Examine the router output above. Which two items are correct? (Choose two.) A. Router A will assume the active state if its priority is the highest. B. If Ethernet 0/2 goes down, the standby router will take over. C. When Ethernet 0/3 of RouterA comes back up, the priority will become 105. D. The local IP address of Router A is 10.1.0.6. E. The local IP address of Router A is 10.1.0.20. Correct Answers: A, C QUESTION 162 In the use of 802.1X access control, which three Read more […]

Cisco CCNP 642-813 Exam Questions 27

Ensurepass QUESTION Which three statements about the Multiple Spanning Tree (MST) protocol (IEEE 802.1s) are true? (Choose three.) A. An MST region is a group of MST switches that appear as a single virtual bridge to adjacent CST and MST regions. B. All switches in an MST region, except distribution layer switches, should have their priority lowered from the default value 32768. C. All switches in the same MST region must have the same VLAN-to-instance mapping, but different configuration revision Read more […]

Cisco CCNP 642-813 Exam Questions 26

Ensurepass QUESTION Refer to the exhibit. On the basis of the information provided in the exhibit, which two sets of procedures are best practices for Layer 2 and 3 failover alignment? (Choose two.) A. Configure the D-SW1 switch as the active HSRP router and the STP root for all VLANs. Configure the D-SW2 switch as the standby HSRP router and backup STP root for all VLANs. B. Configure the D-SW1 switch as the standby HSRP router and the STP root for VLANs 11 and 110. Configure the D-SW2 switch Read more […]

Cisco CCNP 642-813 Exam Questions 25

Ensurepass QUESTION Acme is small export company that has an existing enterprise network comprised of 5 switches; CORE, DSW1, DSW2,ASW1 and ASW2. The topology diagram indicates their desired pre-VLAN spanning tree mapping. Previous configuration attempts have resulted in the following issues: – CORE should be the root bridge for VLAN 20; however, DSW1 is currently the root bridge for VLAN 20. – Traffic for VLAN 30 should be forwarding over the gig 1/0/6 trunk port between DSW1 and DSW2. However Read more […]

Cisco CCNP 642-813 Exam Questions 24

Ensurepass QUESTION Correct Answer: QUESTION 137 Refer to the Exhibit. The information of the question You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20. Also, all VLAN and VTP configurations are to be completed in global configuration mode as VLAN database mode is being deprecated by Cisco. You are required to accomplish the following tasks: 1. Ensure the switch does not participate in VTP but forwards VTP advertisements received on trunk ports. 2. Ensure Read more […]

Cisco CCNP 642-813 Exam Questions 23

Ensurepass QUESTION Which protocol allows for the automatic selection and simultaneous use of multiple available gateways as well as automatic failover between those gateways? A. IRDP B. HSRP C. GLBP D. VRRP Correct Answer: C QUESTION 117 This is a drag and drop question which is about the correct sequence of steps that a wireless client takes during the process of association with an access point(AP). Drag the items to the proper locations. Correct Answer: QUESTION 118 You work Read more […]

Cisco CCNP 642-813 Exam Questions 22

Ensurepass QUESTION Which statement about 802.1Q trunking is true? A. Both switches must be in the same VTP domain. B. The encapsulation type on both ends of the trunk does not have to match. C. The native VLAN on both ends of the trunk must be VLAN 1. D. In 802.1Q trunking, all VLAN packets are tagged on the trunk link, except the native VLAN. Correct Answer: D QUESTION 112 Refer to the exhibit. Which three statements are true? (Choose three.) A. A trunk link will be formed. B. Read more […]

Cisco CCNP 642-813 Exam Questions 21

Ensurepass QUESTION Which Cisco IOS command globally enables port-based authentication on a switch? A. aaa port-auth enable B. radius port-control enable C. dot1x system-auth-control D. switchport aaa-control enable Correct Answer: C QUESTION 107 Which two steps are necessary to configure inter-VLAN routing between multilayer switches? (Choose two.) A. Configure a dynamic routing protocol. B. Configure SVI interfaces with IP addresses and subnet masks. C. Configure access ports with Read more […]

Cisco CCNP 642-813 Exam Questions 20

Ensurepass QUESTION Refer to the exhibit. Which statement about the private VLAN configuration is true? A. Only VLAN 503 will be the community PVLAN, because multiple community PVLANs are not allowed. B. Users of VLANs 501 and 503 will be able to communicate. C. VLAN 502 is a secondary VLAN. D. VLAN 502 will be a standalone VLAN, because it is not associated with any other VLANs. Correct Answer: C QUESTION 102 When configuring a routed port on a Cisco multilayer switch, which configuration Read more […]

Cisco CCNP 642-813 Exam Questions 19

Ensurepass QUESTION A network is deployed using recommended practices of the enterprise campus network model, including users with desktop computers connected via IP phones. Given that all components are QoS-capable, where are the two optimal locations for trust boundaries to be configured by the network administrator? (Choose two.) A. host B. IP phone C. access layer switch D. distribution layer switch E. core layer switch Correct Answer: B,C QUESTION 97 What is needed to verify that Read more […]

Cisco CCNP 642-813 Exam Questions 18

Ensurepass QUESTION d1 Refer to the exhibit. Switch S1 has been configured with the command spanning-tree mode rapid-pvst. Switch S3 has been configured with the command spanning-tree mode mst. Switch S2 is running the IEEE 802.1D instance of Spanning Tree. What is the result? A. IEEE 802.1w and IEEE 802.1s are compatible. IEEE 802.1d is incompatible. Switches S1 and S3 can pass traffic between themselves. Neither can pass traffic to switch S2. B. Switches S1, S2, and S3 can pass traffic between Read more […]

Cisco CCNP 642-813 Exam Questions 17

Ensurepass QUESTION Which two statements about HSRP, VRRP, and GLBP are true? (Choose two.) A. GLBP allows for router load balancing of traffic from a network segment without the different host IP configurations needed to achieve the same results with HSRP. B. GLBP allows for router load balancing of traffic from a network segment by utilizing the creation of multiple standby groups. C. GLBP and VRRP allow for MD5 authentication, whereas HSRP does not. D. Unlike HSRP and VRRP, GLBP allows automatic Read more […]

Cisco CCNP 642-813 Exam Questions 16

Ensurepass QUESTION d1 What is the effect of configuring the following command on a switch? Switch(config) # spanning-tree portfast bpdufilter default A. If BPDUs are received by a port configured for PortFast, then PortFast is disabled and the BPDUs are processed normally. B. If BPDUs are received by a port configured for PortFast, they are ignored and none are sent. C. If BPDUs are received by a port configured for PortFast, the port transitions to the forwarding state. D. The command enables Read more […]

Cisco CCNP 642-813 Exam Questions 15

Ensurepass QUESTION Which protocol will enable a group of routers to form a single virtual router and will use the real IP address of a router as the gateway address? A. Proxy ARP B. HSRP C. IRDP D. VRRP E. GLBP Correct Answer: D QUESTION 77 On a multilayer Cisco Catalyst switch, which interface command is used to convert a Layer 3 interface to a Layer 2 interface? A. switchport B. no switchport C. switchport mode access D. switchport access vlan vlan-id Correct Answer: A QUESTION Read more […]

Cisco CCNP 642-813 Exam Questions 14

Ensurepass QUESTION d1 Refer to the exhibit. BPDUGuard is enabled on both ports of SwitchA. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements about the possible result of attaching the second link are true? (Choose two.) A. The switch port attached to LinkB does not transition to up. B. One or both of the two switch ports attached to the hub goes into the err-disabled state when a BPDU is received. C. Both switch Read more […]

Cisco CCNP 642-813 Exam Questions 13

Ensurepass QUESTION You are the administrator of a switch and currently all host-connected ports are configured with the portfast command. You have received a new directive from your manager that states that, in the future, any host- connected port that receives a BPDU should automatically disable PortFast and begin transmitting BPDUs. Which command will support this new requirement? A. Switch(config)#spanning-tree portfast bpduguard default B. Switch(config-if)#spanning-tree bpduguard enable C. Read more […]

Cisco CCNP 642-813 Exam Questions 12

Ensurepass QUESTION d1 Which two DTP modes permit trunking between directly connected switches? (Choose two.) A. dynamic desirable (VTP domain A) to dynamic desirable (VTP domain A) B. dynamic desirable (VTP domain A) to dynamic desirable (VTP domain B) C. dynamic auto (VTP domain A) to dynamic auto (VTP domain A) D. dynamic auto (VTP domain A) to dynamic auto (VTP domain B) E. dynamic auto (VTP domain A) to nonegotiate (VTP domain A) F. nonegotiate (VTP domain A) to nonegotiate (VTP domain Read more […]

Cisco CCNP 642-813 Exam Questions 11

Ensurepass QUESTION What does the interface subcommand switchport voice vlan 222 indicate? A. The port is configured for both data and voice traffic. B. The port is fully dedicated to forwarding voice traffic. C. The port operates as an FXS telephony port. D. Voice traffic is directed to VLAN 222. Correct Answer: A QUESTION 57 When you create a network implementation for a VLAN solution, what is one procedure that you should include in your plan? A. Perform an incremental implementation Read more […]