[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 671-680

EnsurepassQUESTION 671 Drag the actions on the left to the correct order on the right when doing outside-to-inside NAT translation.     Correct Answer:     QUESTION 672 Drag the statements on the left to the correct OSPF network type on the right.     Correct Answer:     QUESTION 673 What is the purpose of an explicit “deny any” statement at the end of an ACL?   A. none, since it is implicit B. to enable Cisco lOS IPS to work properly; however, Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 681-690

EnsurepassQUESTION 681 When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridge priority be changed to?   A. 8192 B. 16384 C. 49152 D. 65535   Correct Answer: C     QUESTION 682 Which of these best describes the actions taken when a VTP message is received on a switch configured with the VTP mode “transparent”?   A. VTP updates are ignored and forwarded out all ports. B. VTP updates are ignored and forwarded Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 661-670

EnsurepassQUESTION 661 Refer to the exhibit. What is preventing R4 from learning any networks via OSPF?     A. R4 does not have any OSPF neighbors. B. There is no OSPF backup designated router on FastEthernet0/0. C. The OSPF area number for FastEthernet0/0 does not match the interface network. D. There are no OSPF learned routes in the network beyond R4.   Correct Answer: A     QUESTION 662 Refer to the exhibit. What problem does the debug ip ospf event output Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 641-650

EnsurepassQUESTION 641 DRAG DROP Drag and drop each DHCP term on the left to the corresponding definition on the right.     Correct Answer:                                 QUESTION 642 DRAG DROP Drag and drop the EIGRP term on the left to the corresponding definition on the right.     Correct Answer:     QUESTION 643 Which statement is true about conditional advertisements?   Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 651-660

EnsurepassQUESTION 651 DRAG DROP Drag and drop the protocol on the left to the corresponding administrative distance on the right.     Correct Answer:     QUESTION 652 Which object tracking function tracks the combined states of multiple objects?   A. application B. interface C. stub-object D. list   Correct Answer: D     QUESTION 653 In which two situations is an EIGRP hello packet sent as unicast? (Choose two.)   A. during neighbor Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 631-640

EnsurepassQUESTION 631 In an STP domain, which two statements are true for a nonroot switch, when it receives a configuration BPDU from the root bridge with the TC bit set? (Choose two.)   A. It sets the MAC table aging time to max_age + forward_delay time. B. It sets the MAC table aging time to forward_delay time. C. It recalculates the STP topology upon receiving topology change notification from the root switch. D. It receives the topology change BPDU on both forwarding and Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 611-620

EnsurepassQUESTION 611 Refer to the exhibit. RIPv2 authentication is failing on a device with this configuration. Which two actions can you take to enable it? (Choose two.)     A. Set the RIP authentication mode to text. B. Set the RIP authentication mode to MD5. C. Configure the password encryption for the key. D. Set the password encryption to AES.   Correct Answer: AB Explanation: See the reference link below for information on configuring RIPv2 authentication, including Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 601-610

EnsurepassQUESTION 601 Which statement about WAN Ethernet Services is true?   A. Rate-limiting can be configured per EVC. B. Point-to-point processing and encapsulation are performed on the customer network. C. Ethernet multipoint services function as a multipoint-to-multipoint VLAN-based connection. D. UNIs can perform service multiplexing and all-in-one bundling.   Correct Answer: A Explanation: The MEF has defined a set of bandwidth profiles that can be applied at the UNI Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 591-600

EnsurepassQUESTION 591 Refer to the exhibit. You are bringing a new MPLS router online and have configured only what is shown to bring LDP up. Assume that the peer has been configured in a similar manner. You verify the LDP peer state and see that there are no neighbors. What will the output of show mpls ldp discovery show?     A. Interfaces: Ethernet0/0 (ldp): xmit B. Interfaces: Ethernet0/0 (ldp): xmit/recv LDP Id: 25.25.25.2:0; IP addr: 192.168.12.2 C. Interfaces: Ethernet0/0 Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 621-630

EnsurepassQUESTION 621 Which two options are EEM policies? (Choose two.)   A. applets B. event detectors C. scripts D. syslogs E. actions   Correct Answer: AC     QUESTION 622 Refer to the exhibit. Route exchange is failing on a PE edge device configured with this VRF-Lite. Which action can you take to correct the problem?     A. Configure the vrf-lite capability under the OSPF address families. B. Correct the route descriptors. C. Correct Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 581-590

EnsurepassQUESTION 581 Refer to the exhibit. If OSPF is implemented on the network, which additional configuration is needed to allow traffic from host 10.4.1.15/24 to host 10.1.2.20/24?     A. A virtual link between router 2 and router 4 B. A virtual link between router 3 and router 4 C. A virtual link between router 2 and router 3 D. The current design allows traffic between the two hosts.   Correct Answer: D Explanation: This specific traffic from 10.4.1.0/24 to 10.1.2.0/24 Read more […]

[Free] Download New Latest (June 2016) Cisco 400-101 Practice Test 571-580

EnsurepassQUESTION 571 What is the maximum number of secondary IP addresses that can be configured on a router interface?   A. 1 B. 2 C. 4 D. 1024 E. 65535 F. no limit to the number of addresses   Correct Answer: F Explanation: From “IP Routing Frequently Asked Questions”   Q. What are the maximum number of secondary IP addesses that can be configured on a router interface? A. There are no limits on configuring secondary IP addresses on a router interface.   Read more […]